MAGNETO TIMING TOOL

• 100% Solid State Integrated Circuitry
• Pocket Size 3/4 x 3" x 5"
• Bright L.E.D. Readout / Piezo Tweeter
• Reads Inductance Change-not a simple continuity tester; will not 'false-read' clip lead problems
• Long Battery Life.
  
• Strong Anodized Aluminum Case

Operation:
It is recommended that you disconnect spark plug wires to prevent
starting on all Morris Magneto '5' series magnetos. Set any kill
switch(s) to the ON position. Hook up one of the clip leads to the kill
wire stud, and the other lead to ground. Switch tool on. Adjust the
magneto according to engine timing requirements so that "OPEN" lights
up, indicating the moment points open, which is when the magneto spark
occurs. Do not start or run engine with tester connected. Can also be
used on battery ignition systems, or to test relay coils, but battery
must be disconnected first.

With the inherent low draw from the circuitry and LED lights, expect
long life from the battery, but the unit must be switched off when you
are done and tool is put away. Unit uses a 9V battery (4 AA's on
lights-only model), and will need to be replaced if voltage drops below
3V.